Solar-energy Flashlight
Working Principle：
This product adopts the principle of monocrystal silicon PV solar panel and solar energy for power generation, recharge the built-in 700mAh/4.8v NI-HI battery, the storage power then be used for lighting and flashing, it also can recharged the mobile phone with charging cable.
Functions:
1. Recharge the built-in 700mAh/4.8v NI-HI battery by solar energy.
2. LED lighting:1LED on -3LEDs on -3LEDs flashing-off for a circle
3. The built-in NI-HI battery can charge mobile phone directly also with an indicator lighting when charging.
Main technical parameter:
|
|
ITEM
|
PARAMETER
|
UNIT
|
ITEM
|
PARAMETER
|
UNIT
|
|
|
Max. brightness
|
Max charging current of solar-energy
(1 pc solar panel )
|
50
|
mA
|
|
|
1LED
|
25000
|
Mcd
|
|
|
|
3LEDs
|
65000
|
Mcd
|
Max charging current of solar-energy
(2 pcs solar panel)
|
100
|
mA
|
|
|
Max. Luminous flux
|
|
|
Max charging current of solar-energy
(3 pcs solar panel)
|
150
|
mA
|
|
|
1LED
|
2
|
Lm
|
|
|
3LEDs
|
5.4
|
Lm
|
Flash frequency
|
2
|
HZ
|
|
|
Lighting time after fully charged
|
LED lifetime
|
50000
|
Hour
|
|
|
1LED
|
35
|
Hour
|
Switch lifetime
|
100000
|
Time
|
|
|
3LEDs
|
15
|
Hour
|
Plastic lifetime
|
5
|
Year
|
|
|
3LEDs flashing
|
35
|
Hour
|
Whole unit lifetime
|
5
|
Year
|
|
|
Lighting time after 1 hour direct sunlight
|
|
|
|
1LED
|
15
|
Hour
|
|
|
|
|
|
3LEDs
|
6.5
|
Hour
|
|
|
|
|
|
|
3LEDs flashing
|
15
|
Hour
|
|
|
|
Use method:
1. Three charging models(charge by solar energy)
① Charged by 1 pcs solar panel : showing the solar panel as picture A, Then Put the front of it under the sun light to charge built in battery.
② Charged by 2 pcs solar panel : showing the solar panel as picture B, Then put the front of it under the sun light to charge built in battery.
③ Charged by 3 pcs solar panel : showing the solar panel as picture C, Then Put the front of it under the sun light to charge built in battery.
2. lighting
LED lighting model: 1LED on –3LEDs on –3LEDs Flashing-off for a circle.
3. Recharge mobile phone :
① Open the DC socket cover, insert one end of charging cable to products socket and plug opposite end to the mobile phone, then the built-in battery can charge mobile phone directly, the indicator will light when charging, more charging current more bright.
Note: if the mobile phone can not be charged, that means there is not enough power of NI-HI battery. At this time. the NI-HI battery must be recharged by the original electronic power firstly.
Cautions:
1. Avoid pointing the light at eyes
2. The pin must be inserting to the socket properly otherwise the electronic circuit will be disturbed.
3. This product is for emergency use only.
4. Strictly using the specified mobile phone cables to charge mobile phone, otherwise the mobile phone or its battery will also be damaged.
